Kolab Project Vape How to Use: Charge & Fix
Kolab Project makes 510 thread vape cartridges (1g) and the Pure Diamonds AIO disposable vape pen (1g), both sold at Ashario Cannabis in Ontario. A 510 cartridge needs a separate 510 battery to work; the Pure Diamonds AIO arrives charged and ready, with no screwing or filling required. Below is how to use, charge, and fix both.
Note: Cannabis is for adults 19+ in Ontario. This content is for informational purposes only and is not medical advice. Consult a healthcare professional for cannabis-related health questions.
You'll find the Kolab Project lineup, including the Yuzu Honey and Guava OG 510 cartridges, on the shelf across our stores. Check the live menu for your nearest Ashario store before you head out, since stock shifts week to week. For a quick primer on vape formats, our cannabis blog covers related guides too.
How do you use a Kolab Project vape?
To use a Kolab Project 510 cartridge, screw it onto a charged 510 battery, then draw slowly from the mouthpiece. Button-style batteries fire while you hold the button; draw-activated batteries fire when you inhale. The Pure Diamonds AIO disposable is simpler: just inhale from the mouthpiece, no battery or assembly needed.
The two products behave a little differently, so here's each one.
Kolab Project 510 thread cartridge
The 510 cartridges in stock include Yuzu Honey, Pink Lychee, Strawberry Ice Diamonds, Blue Passionfruit, Pineapple Heat, Guava OG, Sour Mango, and the Liquid Live Resin 510 Thread Cartridge (all 1g). "510" refers to the universal threading at the base, so these screw onto most standard 510 batteries. Steps:
- Charge your 510 battery fully before first use.
- Thread the cartridge on gently. Hand-tight only; overtightening can crush the connection and stop airflow.
- If your battery has voltage settings, start on the lowest. Too much voltage can scorch the oil and give a harsh, burnt taste.
- Take a slow, steady draw of 2 to 3 seconds. Hold the button first if it's a button model.
- Wait a moment between puffs so the oil can re-saturate the coil.
Kolab Project Pure Diamonds AIO disposable
The Pure Diamonds AIO (1g) is an all-in-one disposable: battery and oil are sealed together in one unit. Most are draw-activated, so there's no button. Remove any mouthpiece sticker, inhale slowly, and you're set. When the oil runs out or the battery dies, the device is spent and should be recycled. Some AIO units include a charging port for the final puffs; see the charging section below.
How do you charge a Kolab Project vape?
For a 510 cartridge, you charge the separate 510 battery, not the cartridge itself, usually via a USB cable into the battery's charge port. For the Pure Diamonds AIO disposable, charge only if it has a visible USB-C or micro-USB port, and only to finish remaining oil. A disposable is never meant to be refilled.
Practical charging tips that save a lot of frustration:
- Use a low-amp USB source like a laptop port or a 1A wall adapter. High-output fast chargers can overheat small vape batteries.
- Watch the indicator light. A steady or colour-shifting light usually means charging; it typically turns off or goes green when full.
- Unplug once charged. Leaving a small battery on the charger overnight shortens its lifespan.
- Never charge a device that feels hot, looks swollen, or has a damaged port. Stop and recycle it safely.
If you already own a 510 battery from another vape, the same charging routine applies. Our Spinach 510 Battery: Use, Charge & Fix It Fast guide walks through 510 battery charging in more detail.
Why is my Kolab Project vape not working?
A Kolab Project vape most often stops working because of a dead battery, a loose or overtightened cartridge connection, a clogged mouthpiece, or an air bubble blocking the coil. For the Pure Diamonds AIO disposable, a weak draw usually means the oil is nearly finished or the battery is depleted. Work through the fixes below in order.
No vapour at all
- Charge first. With a 510 setup, the most common cause is a flat battery. Charge it fully and retry.
- Check the connection. Unscrew the cartridge, then reattach it hand-tight. A plate at the battery's centre pin that's pressed too deep can break contact; a small, careful nudge outward can restore it.
- Confirm the battery is on. Many 510 batteries use five rapid clicks of the button to switch on and off.
- Clear the mouthpiece. Residue can block airflow. Wipe it with a dry cotton swab.
Weak hits or a clogged feel
- Warm it gently. In cold Ontario weather, oil thickens. Hold the cartridge in your hand for a few minutes before using.
- Prime with short pulls. A couple of light, button-off draws can pull oil back toward the coil.
- Lower the voltage. If your battery is adjustable and hits feel harsh, drop a setting.
- Check for a bubble. Store the cartridge upright, mouthpiece up, so oil settles over the coil.
Burnt or harsh taste
A burnt taste usually means the voltage is too high or the coil is running dry. Lower the voltage, take slower draws, and pause longer between puffs. If the device is near empty, that scorched note means it's spent. For disposable units, that's your cue the Pure Diamonds AIO has reached the end.
Dual-chamber and disposable troubleshooting shares a lot of overlap. If you want a broader checklist, our Dual Chamber Vape Not Hitting? Fix It Fast and Spinach Disposable Vape Instructions guides cover more scenarios.
Where can you buy Kolab Project vapes in Ontario?
As of 2026, Ashario Cannabis stocks Kolab Project 510 cartridges at all four stores: Finch & Dufferin (1111A Finch Ave W Unit 1, North York), Centerpoint Mall (6464 Yonge St Unit #187, North York), Aurora (15114 Yonge St), and Thornton (239 Barrie St). The Pure Diamonds AIO disposable is currently at Finch & Dufferin and Aurora. All stores open 7 AM to 11 PM daily.
Cannabis vapes are legal for adults 19 and over in Ontario, regulated under the federal Health Canada Cannabis Act and sold through licensed retailers overseen by the AGCO. Potency and terpene content vary by product and lot, so always verify the details on the current label or COA in store rather than relying on any online figure.
Because availability changes often, confirm your flavour and format on the live store menu or call ahead. You can find addresses and phone numbers on our store locations page, and reach us through contact us with any product question.
Quick storage and care checklist
Proper storage keeps a Kolab Project vape drawing smoothly for its full life. Store cartridges upright and away from heat, keep batteries partly charged if unused for weeks, and never leave a vape in a hot car or freezing garage. Ontario's temperature swings are the number one reason cartridges clog or leak.
- Keep the mouthpiece cap on when not in use to block dust.
- Store upright so oil stays over the coil.
- Avoid direct sunlight and heat near 25C and above.
- Recycle spent disposables and empty cartridges responsibly, not in household garbage.
Treat a disposable AIO as single-use. Don't try to open, refill, or rewire it. Doing so risks leaks and damaged electronics, and it voids any manufacturer support.
Visit Ashario Cannabis
Want to try the Guava OG or Yuzu Honey 510 cartridge, or the Pure Diamonds AIO disposable? Pick them up in person at one of our four Ontario stores, or check the live menu for your closest location first. Staying home instead? Order same-day cannabis delivery in North York, Thornhill, Richmond Hill and Markham, available 10 AM to 10 PM daily. You must be 19+ with valid government-issued ID.
Frequently asked questions
Can I refill a Kolab Project 510 cartridge?
No. Kolab Project 510 cartridges are sold as sealed, pre-filled 1g units and are not designed to be refilled. Attempting to pry one open usually damages the coil or causes leaks, and it ruins the airflow. When a cartridge is empty, recycle it responsibly and pick up a fresh one from the live menu at your nearest Ashario store.
What battery voltage works best with a Kolab Project cartridge?
Start on the lowest setting your 510 battery offers and work up only if the vapour feels too thin. Lower voltage preserves flavour and prevents a burnt taste, while higher voltage can scorch the oil. If your battery is a simple single-voltage model, it's already tuned for standard 510 cartridges, so no adjustment is needed.
Why does my Kolab Project disposable taste burnt when it's nearly empty?
A burnt taste as a disposable runs low usually means the coil is pulling less oil than it needs, so it overheats the small amount left. That's a normal sign the Pure Diamonds AIO is almost finished. Take slower, shorter draws for the last few puffs, then recycle the unit. Forcing hard pulls on a near-empty device only makes the scorched note worse.
My Kolab Project 510 cartridge leaks a little. Is that a defect?
Minor condensation or a small amount of oil near the threading is often caused by temperature changes or storing the cartridge on its side. Keep it upright, cap on, and away from heat. Wipe the contact point with a dry swab before screwing it on. If the cartridge leaks heavily or won't seal, bring it to any Ashario store or reach out through our contact page.
Do I need a special charger for a Kolab Project vape?
No special charger is required. A 510 battery charges through its own USB cable, and any Pure Diamonds AIO with a charge port uses a standard USB-C or micro-USB cable. Use a low-amp source like a laptop port or a 1A wall adapter rather than a high-output fast charger, and unplug once the indicator light shows a full charge.
Important Notice: Content on this website is intended strictly for informational purposes. Ashario does not promote any product or represent that the products mentioned on Ashario's website are treatments for any kind of medical condition. Ashario cannot guarantee that information provided is error-free or complete and is not responsible for the quality of the information provided by users. Ashario does not endorse any user-reported information, any particular strain, product, producer, organization, treatment, or therapy.